The Roadmaster Stop Light Switch Kit # RM62FR is needed because the brake light switch wire of the 2020 Buick Encore GX isn't useable and this simulates the braking signal so that it can be sent out to the braking system. This allows you to see when the brakes are being applied while flat towing, which is important because you can easily verify if the brakes are activating when they shouldn't be or not activating when they need to so that you can pull over and troubleshoot the issue.
A... view full answer...
When flat towing any vehicle we have to recommend you stick with what the vehicle manufacturer outlines as the flat towing procedure in the owners manual. In most cases the reason is because the steering wheel has to be unlocked and the only position the steering wheel is unlocked for some vehicles is with the key on which is why then the battery has to be disconnected so it doesn't drain quickly.
You'd have to check with Buick to get that totally verified but if you left the key on for... view full answer...
The Roadmaster base plate kit part # RM32FR that fits your 2022 Buick Encore GX will not affect the front collision warning sensors or braking.
In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting, and supplemental braking to flat tow your vehicle. The most popular compatible tow bar is the Falcon All Terain, # RM-522. This has non-binding arms which makes the setup very easy to connect/disconnect.
For lighting/safety cables, locks, and covers... view full answer...
The 2020 Buick Encore GX needs to have the battery disconnected while flat towing the vehicle per manufacturer instructions. This is to ensure the safety of your vehicle's components. Typically this is to prevent the steering wheel from locking and causing your tires to drag anytime you make a turn.
To make this as simple as flipping a switch you can install the Roadmaster Automatic Battery Disconnect with Switch for Towed Vehicle w/ Supplemental Braking System # RM-766. This will allow... view full answer...
When installing the Curt Trailer Hitch Receiver # C94UR, you need to trim a 2-5/8" wide by 1-3/8" tall square into the underbody panel as seen in the instructions that I attached for you. I also attached a section of the instructions that shows exactly where to cut the plastic panel. view full answer...
The Roadmaster Automatic Battery Disconnect with Switch for Towed Vehicle w/ Supplemental Braking System, # RM-766 is designed to function on the positive side of the battery. For the relay to be energized, it must be installed as designed. view full answer...
The Replacement Switch for Roadmaster Automatic Battery Disconnect, part # RM57ZR, is not weatherproof. One of the installation requirements of the Roadmaster Automatic Battery Disconnect with Switch for Towed Vehicle w/ Supplemental Braking System, part # RM-766, is that it needs to be protected from direct road spray. In my opinion, the wheel well would provide too much spray and the switch and/or solenoid would get wet.
I have included a product description link, a video demo, and... view full answer...
Go To Results